Filter
Top Products
SPEEDDOME ULTRA VII CAMERA DOME CONFIGURATION UTILITY 8200-0184-09, REV. A
OPERATOR’S MANUAL SUPPLEMENT
6 of 13
Command Function
(Zoom In) or
Twist joystick
clockwise
Move the cursor to the right of
the current character in the
name or password.
(Zoom Out)
or Twist joystick
counterclockwise
Move the cursor to the left of
the current character in the
name.
Additional Dome Commands
Table 5 provides the special commands available
when using the dome in an AD-UTC network.
These commands are available when you enter the
keyboard combination provided.
Table 5: Additional Dome Commands
Command Function
F
(Function),
Preset # (1-96), and
then
(Preset)
Program selected Preset
Preset # (1-96), and
then
(Preset)
Recall selected Preset
F
(Function),
pattern # (1-3), and
then
+
(Shift+Preset)
Start selected Pattern
programming
Pattern # (1-3), and
then
F
(Function)
Save Pattern programming
Pattern # (1-3), and
then +
(Shift and Preset)
Run selected Pattern
continuously
F
+
(Function+Focus Far)
Or
F
+
(Function+Focus
Near)
Resume Auto Focus mode
F
+
(Function+Iris Open)
Or
F
+
(Function+Iris Close)
Resume Auto Iris mode
(Flip)
Rotate dome 180° from current
position (“flip”)
Performance Notes
Keep the following considerations in mind when
using the SpeedDome Ultra VII camera dome in
the AD-UTC environment.
Address Setting
The SpeedDome Ultra VII camera dome must be
set to address 891 to operate in the AD-UTC
environment. When the dome initializes or resets,
the address and protocol information (UTC_T)
appear on-screen.
Accessing the Quick Set Menu
The Quick Set Menu provides easy access to
specific SpeedDome Ultra VII functions from the
keyboard. To access the Quick Set menu, select
the dome, and press
(Quick Set button).
See Quick Set Menu on page 2 for information
about the Quick Set functions.
SensorNet and RS-422
Matrix Switchers and
Controllers
The following provides information about
SensorNet and RS-422 controllers compatible with
SpeedDome Ultra VII. Specific operating
considerations are also included.
VM8
Supported Protocol SensorNet
Maximum Presets 0
Maximum Patterns (1) 1
Quick Set Menu Not supported
Address Range 1-8
Notes:
(1) Apple Peel only. Programmable patterns are
not available.