Filter
Top Products
Page8
PREPARATION OF THE LENS
Depending on the lens used, there are a number of gear options possible. Using the right gear (s) and correctly mounting
them on the lens is very important for a smooth housing operation. Use the following chart to determine which gear(s) to
use and follow the installation directions for each gear carefully. Since the aperture control is achieved through the Sub-
Command Dial, the use of AF types of lenses is mandatory. The focus/zoom gear can vary from one lens to the other.
A complete gear selection chart is available on our web site at www.aquatica.ca
- If the camera is set in autofocus, a focus gear is not required.
- If the camera is set in manual focus or if you are using a zoom lens, a focus/zoom gear must be mounted
on the lens.
- If you are using a zoom lens with an 8” dome port you may need to install a close-up diopter on the lens to
correct the minimum focusing distance of the lens so that it will be able to focus on the virtual image created
by the dome.
Focus Gear installation:
1. Set the lens to minimum focus distance.
2. Mount the focus gear over the focus ring of the lens such that the round indentation etched on the side of the
gear is facing the rear of lens and is aligned with the Distance Index of the lens (for full gears orientation
is immaterial).
3 (a) For Slip-on gears (gears without mounting screws): Slide the gear over the lens and align the gear with the
front of the lens focusing ring.
(b) For gears with mounting screws: Tighten the three set screws evenly. Tighten each screw approximately ½ a turn
working around the gear until all the three (3) screws are tightened and making sure the gear is concentric with
the lens body.
CAUTION: Do not over-tighten these screws, as this might bind the lens thus restricting the rotation of the focus ring and/
or damaging the lens. Conversely under-tightening these screws might cause the gear to slip or lose alignment.
4. Rotate the focus ring several times to make sure it moves smoothly and the gear does not slip before closing
the housing
Refer to the Lens Chart on www.aquatica.ca for updating of lenses that can be used in the housing.
WARNING: Never attempt to operate the camera in auto focus mode when a NON USM lens is mounted with a focus
gear. This might cause serious damage to your camera or to the lens.