Filter
Top Products
ARRIFLEX 416 Quick Guide 02/2007, Page 10
Mounting the Magazine
• Insert the magazine throat into the magazine aperture in the back of the camera body and slide the
magazine forward until it locks in place.
Note: If the Shoulder Pad is attached to the camera, you will need to push down on the Shoulder Pad before
inserting the magazine.
• Flip the silver Safety Catch on the Magazine Release Lever forward to prevent accidental release of the
magazine.
• Inch the camera by briefly pressing the PHASE button.
Note: After a new magazine has been attached or after camera power has been turned on, you should always
push the PHASE button to perform a loop check (the display shows ‘loop’). This takes about 2 seconds and
will engage the pulldown claw, check loop size and centre the loop properly.
Mounting the Magazine
Safety Catch (in
locked position)
Magazine
Release Lever