Filter
Top Products
To program an automatic pause for redialed numbers
To dial a number with a programmable dialing button
1
Pick up handset
or
if you are using an 8110 telephone, you can press [
Spkr ]
2
When you hear dial tone, press appropriate programmable dialing
button
●
Number programmed on the button is automatically dialed
To erase a number stored on a programmable dialing button
1
2
3
Press the PROGRAM button
Press button to be cleared twice
Press the PROGRAM button
or
lift handset
Redial (With Auto-Pause)
The Redial feature automatically redials the last number you dialed from
the dial pad, either an extension or an outside number. Use to save time
in redialing a busy or unanswered number. The number you redial can
be up to 20 digits.
The Auto-Pause feature can automatically insert pauses after a dial
access code (such as, 9) in a redialed number. If you usually wait a
short period to obtain a second dial tone after dialing an access code,
you can set the waiting time needed by the Redial feature by
programming the Auto-Pause feature as described below.
To automatically redial the last number dialed from the dial pad
1
Pick up handset
or
if you are using an 8110 telephone, you can press [
Spkr
] [dial tone]
2
Press [
Redial
]
● Number is automatically redialed
To erase ALL stored access codes
Note: You will hear a rapid error tone if the dialed number is longer
than 20 elements.
1
2
3
4
While the telephone is on-hook,
press the PROGRAM button
[programming tone]
Press [
Redial
]
Press the appropriate access code and number of pauses in order to
insert a long enough waiting time to obtain a second dial tone.
For example, if you need 2 pauses inserted between the access
code, such as 9, and the remainder of the telephone number you are
dialing, press the PAUSE button twice
Note: You may store up to 3 different access code/pause
combinations. Each code can have up to 3 characters and up
to 4 pauses.
Press the PROGRAM button again
EXAMPLE: In the following example, there are 3 different access
code/pause combinations.
1
2
3
4
5
6
1
2
3
Press the PROGRAM button
[programming tone]
Press [
Redial
]
Dial 9 and then press the PAUSE button 3 times (PAUSE PAUSE
PAUSE). Since each depression of the PAUSE button adds
.5 seconds of waiting time, 3 depressions of the PAUSE button will
add 1.5 seconds of waiting time.
Dial *9 (the second access code needed in the dialing sequence in
this example) and then press the PAUSE button 2 times (PAUSE
PAUSE)
Dial *8 (the third access code needed in this sequence) and then
press the PAUSE button 4 times (PAUSE PAUSE PAUSE PAUSE)
Press the PROGRAM button again
●
The access code sequence is stored for redialing at a later time.
Now, when you press [
Redial ] to redial a call using one of the
above access code/pause combinations (for example,
9 1 212 555 1234), the telephone will automatically insert the
correct number of pauses (3 in this example) to ensure waiting
the appropriate length of time to obtain a second dial tone.
Press the PROGRAM button
[programming tone]
Press [
Redial
] twice
Press the PROGRAM button again
28
29