Filter
Top Products
Page 8 AXIS Q1602-E/AXIS Q1604-E Installation Guide
Install the hardware
Follow the instructions below to install the network camera.
Install the wall bracket
1. Use the supplied drill template to prepare a wall or pole for installation of the wall bracket.
2.
Route the network cable through the wall bracket, and through the bracket adapter. Leave
approximately 30 cm (11.8”) of cable for connecting the camera.
3. Install the wall bracket on a wall, ceiling, or pole and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
Notes:
• The weight of the camera is shown in the table below. Check that the material is strong enough to
support this weight.
• For further technical specifications, please see the User Manual, available on the CD included in this
package, or from www.axis.com
Route network cable (and optional cables) through cable hole
1. Loosen the cable cover screws; detach the cable cover from the bottom cover.
2. Remove the cap, the plug and the gasket from the cable gland that is to be used.
3. Route the network cable through the cap.
4. Slide the network cable through the slit on the gasket to attach the gasket to the network
cable.
5. Route the network cable through the cable gland.
6. Press the gasket into the cable gland and screw the cap on firmly.
Model Weight
AXIS Q1602-E 3.2 kg (7.2 lb.)
AXIS Q1604-E 3.2 kg (7.2 lb.)
Cable gland
Gasket
Plug
Cap