Filter
Top Products
AXIS Q1604-E Network Camera
Events
For more information, see the online help .
Triggers
Available action rule triggers and conditions include:
• Applications – Use installed applications to trigger the rule. See Applications on page 37.
• Detectors
- Audio Detection – Trigger the rule when audio is detected. See Audio Detection on page 36.
- Day/Night Mode – Trigger the rule when the product switches between day mode (IR cut lter on) and night
mode (IR cut lter off). This can for example be used to control an external infrared (IR) light connected
to an output port.
- Live Stream Accessed – Trigger the rule when any stream is accessed and during edge storage playback.
This can for example be used to send notications.
- Motion Detection – Trigger the rule when motion is detected. See Motion Detection on page 34.
- Tampering – Trigger the rule when tampering is detected. See Camera Tampering on page 34.
• Hardware
- Network – Trigger the rule if network connection is lost or restored. This can for example be used to start
recording to the SD card.
- Temperature – Trigger the rule if the temperature falls outside or inside the operating range of the product. This
can for example be used to send maintenance notications.
• Input Signal
- Digital Input Port – Trigger the rule when an I/O port receives a signal from a connected device. See I/O
Ports on page 57.
- Manual Trigger – Trigger the rule using the Manual Trigger button in the Live View page. See Controls on
the Live View Page on page 14. This can for example be used to validate actions during product installation
and conguration.
- Virtual Inputs – can be used by a VMS (Video Management System) to trigger actions. Virtual inputs can, for
example, be connected to buttons in the VMS user interface.
• Storage
- Disruption – Trigger the rule if storage problems are detected, for example if the storage device is unavailable,
removed, full, locked or if other read or write problems occur. This can for example be used to send maintenance
notications.
- Recording – Triggers the rule when the Axis product records to the storage device. The recording status trigger
can be used to notify the operator, for example by ashing LED lights, if the product has started or stopped to
record to the storage device. Note that, this trigger can be used only for edge storage recording status.
• System
- System Ready – Trigger the rule when the product has been started and all services are running. This can for
example be used to send a notication when the product restarts.
• Time
- Recurrence – Trigger the rule periodically. See Set Up Recurrences on page 43. This can for example be used to
upload an image every 5 minutes.
- Use Schedule – Trigger the rule according to the selected schedule. See Create Schedules on page 42.
40