Filter
Top Products
AXIS T90B Series
• Telemetry TEL enabled
• Telemetry input wires soldered together for automatic
photocell operation
• Telemetry DIM disabled
• LED status indicators enabled
• Programming Mode
Note
Changing the settings requires a remote control (optional
accessory). The illuminator must be in Programming Mode.
The illuminator automatically switches from Programming
Mode to Normal Operating Mode after 4 weeks. To switch to
Programming Mode, restart the illuminator.
1. Adjust the power, see Power Adjust on page22.
2. Adjust the photocell sensitivity, see Photocell Sensitivity on
page 22.
3. Set the telemetry input:
- TEL, see page 24
- DIM, see page 25
- Timer, see page 25
4. Disable the LED status indicators, see LED Status Indicators
on page 26.
5. Disable remote control setup, see Disable Remote Control
Setup on page 27.
6. Restore the factory default settings, see Factory Default on
page 27.
Normal Operating Mode
The only function of the Remote Control available during Normal Operating
Mode is LED Status Indicators, see LED Status Indicatorson page 26.
21
ENGLISH