Filter
Top Products
AXIS T90B Series
1. Turn the light on (night) and off (day) automatically via the
photocell. This is the standard factory setting, no further
action is required.
2. Turn the light on and off from a remote switch or input.
3. Used in conjunction with the Timer Function to turn the light
on for a pre-dened period of time.
Telemetry - DIM
The remote dimming feature allows the brightness of the illuminator to be
controlled remotely using the telemetry input wires. Use the DIM button
to select this function.
When the DIM function is selected, a telemetry input into the illuminator
will vary the brightness up and down. When the telemetry input is rst
applied, it will start to dim the light and will continue to do so while the
telemetry input is active. When telemetry input stops, the light level will
stay where it was set. When the telemetry input is activated for a second
time, the light will start to brighten. This will continue while the telemetry
input is active. This activation and de-activation of the telemetry input
will reverse the way the light is dimmed (dim down and dim up), to allow
the user to set exactly the level required. Disable the DIM function by
pressing the TEL button.
After setting a specic light level using the DIM function, if DIM is disabled
and TEL enabled, the last power level set when using the DIM function
will be remembered and used by the system unless a new power adjust
button is selected.
Timer
The timer function allows the illuminator to be triggered via a telemetry
input and remain on for a pre-dened period of time. There are four
pre-dened times and a timer disable function. To select timer function,
rst press and release the TEL button, then select the duration of the timer
as shown below.
25
ENGLISH