Filter
Top Products
AXIS 2110 Installation Guide - English Page 5 of 5
Reinstating the Factory Default Settings
In certain circumstances, it may be necessary to reinstate the Factory Default settings for your AXIS
2110. This is performed by clicking the appropriate button within the Administration Tools, or by
pressing the Control Button. Follow the instructions below to reinstate the product factory default
settings using the Control button:
1. Switch off the AXIS 2110 by disconnecting the power cable.
2. Press and hold the Control Button depressed, and reconnect the power supply cable.
3. Continue to keep the Control Button pressed until the Status Indicator displays yellow (note that
this may take up to 15 seconds), then release the Control Button. When the Status Indicator
displays green (which can take up to 1 minute) the AXIS 2110 will then have been reset to the
original factory default settings.
Note: Reinstating the original default settings causes all parameters (including the IP address) to be
reset.
Mounting and Focusing Your Camera
The AXIS 2110 can be mounted on the supplied mounting assembly, or installed into a weatherproof
enclosure for use in outdoor applications. For further information on outdoor enclosures, follow the
camera accessory links at the Axis website at www.axis.com
Having mounted the AXIS 2110, focus the camera following the instructions below:
Important!
Tip! When mounting the camera behind glass, make sure that the camera lens is not too far away from
the glass - particularly when installing the unit in an outdoor enclosure. This will help reduce
undesirable reflection within the image.
Although the AXIS 2110 is intended for indoor and outdoor use, it is important to note that the charged coupled
device (CCD) in the camera can become permanently damaged if it is exposed to too much direct sunlight, or halo-
gen light. Therefore, it is important that the Iris Adjustment Ring is not set fully open when installing the camera in
bright light conditions. The Axis warranty does not cover CCD damage caused by prolonged exposure to strong light.
Rotate the Focus Ring to an
appropriate positon - until you
are satisfied with the focus of
the camera image.
Status Indicator
Power-on the AXIS 2110 and wait 10 seconds.
Control Button
Iris Adjustment Ring
Tele/Wide Zoom Ring
Focus Ring
The Iris Adjustment Ring effectively closes and
opens the camera lens to regulate the amount of
light entering the camera. Closing the ring reduces
the amount of light; this protects the CCD and
gives a better depth of field, i.e. focus over a
greater distance. A more open lens provides better
results in low-light conditions.
Rotate the Iris Adjustment Ring to an appropriate
position for your chosen installation, as follows:
• indoor scene - fully open (O)
• outdoor scene - mid position
(between C and O)
Start your browser applica-
tion and check the picture.
Adjust the Tele/Wide Zoom
Ring to a suitable postion for
your application.
2110ig_master_smaller.fm Page 5 Friday, September 14, 2001 12:54 PM