Bosch Appliances LTC9412/00 Security Camera User Manual


  Open as PDF
of 4
 
A
B
C
D
E
F
G
Bosch Security Systems
14 November 2003
EN
3
LTC9412/00 Instruction Manual Installation
5 EXPLODED VIEW
Description Part number Qty.
A Clamp connector 70-WPCR02 1
B 12" ABS housing (black) 21-TOP123 1
C EMT connector 70-WPCR01 1
D Camera bracket 30-VL1361 1
E 12" dome liner 20-LNOP123 1
F Hartwell fastener 95-FSPLO1(2) 3
G 12" OP clear dome RCOP123 1
4.6. Remove the set screw and drill an approximately 7/32" hole
at the point where the set screw dimples the conduit. Remove
the burrs and replace the set screw.
4.7. Attach the longer arm of the camera bracket to the end of
EMT connector using the clamp nut. Tighten (Figure 3).
Figure 3 Attach bracket arm to EMT connector
4.8. Attach the other bracket arm using a carriage bolt, 5/16”
washer, lockwasher, and hex nut. The camera mounting side
may be facing either in or out (Figure 4).
Figure 4 Attach other bracket arm
4.9. Connect the camera to the camera bracket and adjust to desired
viewing position. Tighten all connections. Complete wiring of
the camera.
4.10. Place the liner inside the dome. Hold the dome and liner up to
the housing and align the 3 Hartwell Fasteners in the dome to
the match ing holes on the housing. Ensure that the cutout in
the liner is aligned with the camera. Once it’s correctly
positioned attach the dome to the housing by pressing the
Hartwell Fasteners into the fl ange of the dome (Figure 5).
Figure 5 Attach the dome to the housing
Hartwell Fasteners
A
B
C
D
E
I
H
G
F
Description Qty.
A VL1361 bracket 1
B 1/4-20 hex nut 1
C 1/4" split lockwasher 1
D 1/4" fl at washer 1
E FM2 bracket 1
F 5/16" washer 1
G 1/4-20 x 3/4" carriage bolt 1
H 1/4-20 x 1/2" hex bolt 1
 previous