Filter
Top Products
LTC 9449 Series | Instruction Manual | Installation
Bosch Security Systems | October 10, 2006
EN
|
9
4.2 Vertical Surface Mounting
1. The Pendant Wall Arm (LTC 9540) is used to
mount the pendant to a wall or vertical surface.
2. Feed the power/video cables through the wall
mount. Securely mount the bracket in the desired
location using 4 fasteners (FIGURE 3). 8mm
(5/16in) bolts/studs are recommended. Bolts should
be secured with nuts, washers, and lock washers.
Fasteners and surface should withstand 270kg
(600lb).
Figure 3: Pendant Arm Mounting
3. Make the electrical connection to the supplied
mating connector. (See FIGURE 2).
NOTE: On both 24VAC and 12VDC units, either wire
can go to either of the specified pins on the
mating connector.
In multiple camera installations using 24VAC
units, connect the wires to the same connectors
to ensure proper camera phasing.
a. Connect the 24VAC or 12VDC power
leads to the 24VAC pins and tighten the
screws.
b. Connect the video lead to the BNC
connector located on the top of the
housing.
4Connect the mating connector securely to the
connector on the connector plate.
4.3 Attaching the Dome to the Mount
1. Once the mount is in place, attach the safety cable
to the eyehook on top of the unit.
2. Align the ears on the connector plate with the
cutouts in the underside of the mounting
arm/ceiling mount.
3. Insert the unit vertically until the bottom face of the
mount touches the top face of the unit.
4. Twist 90 degrees in the direction shown in
FIGURE 4.
5. Allow the unit to drop into place (the unit should
not rotate back to the initial position without lifting
slightly).
6. Tighten the 2 set screws.
NOTE: Do not apply significant force when tightening.
Figure 4: Attaching the Dome
136.1
5.36
186.9
7.36
432
17.0
mm
in
LTC 9540
Mounting Arm
188
7.4
101.6
4.00
(4) 0 9.65
0.38
152.4
6.00
136.1
5.36
344.4
13.56
73.2
2.88
mm
in
Connector Plate
Set Screw
Safety Cable
Eyehook