Filter
Top Products
FlexiDomeHD 720p IP Camera Installation | en 25
Bosch Security Systems Installation and Operation Manual AR18-10-B013 | v1.52 | 2011.06
To disassemble the unit proceed as follows:
1. Using the special screwdriver bit, loosen the three tamper-
resistant screws in the dome trim ring (the screws remain
in place).
2. Remove the dome by pulling it off of the base.
3. Remove the inner liner by pulling it off of the base.
4. Remove the pink protection foam.
5. Loosen the three Phillips screws. Remove the single screw
holding the camera module in place (no keyhole).
6. Rotate the camera module to remove it from the remaining
two screws.