Filter
Top Products
FlexiDomeHD 720p IP Camera Installation | en 35
Bosch Security Systems Installation and Operation Manual AR18-10-B013 | v1.52 | 2011.06
5.6 Closing the unit
When the camera position is set and all adjustments have been
made, close the unit.
1. If necessary, remove the adjustment cap from the lens.
2. Place the inner liner in position aligning its fin with the
bracket on the base.
3. Place the dome onto the base and rotate until it clips into
place. (If necessary, clean its surface with a soft cloth.)
4. Place the sealing ring and the trim ring over the dome.
5. Align the tamper-resistant screws in the trim ring with the
threaded ends in the mounting base.
6. Use the supplied special screwdriver bit to tighten the
three tamper-resistant screws.