Filter
Top Products
FLEXIDOME HD VR Installation | en 31
Bosch Security Systems Installation Manual AM18-Q0637 | v1.1 | 2013.08
1. To rotate the image 180°, press and hold the Menu button
until the image flips.
2. Briefly press the Menu button to set the start position for
the automatic motorized focus adjustment.
– You will hear the motorized automatic back focus
process running.
– The progress is shown on the monitor.
3. Briefly press the Menu button again and again to scroll
through the preset zoom positions.
– The selection loops back to the beginning when you
reach the last one.
4. When you reach the desired zoom position, use a long
press of the Menu button to set the zoom position and to
re-focus.
5. If the camera is not correctly focussed, press the Menu
button for a longer time to restart the wizard.
If the camera is correctly focussed, press the Menu button
for a short time to change the analog output.
6. To change the analog output state, press the Menu button
for a short time.
– Briefly press the Menu button again and again to
select NTSC on, PAL on or OFF (default).
7. When the selection is made, use a long press of the Menu
button to save the results.
– The zoom and focus position is stored.
– The iris is set to its original value.
– The video service output is disabled.
– The BNC video output is set to its selected state.
Note:
If the BNC video output is set to On, the second IP stream is
disabled.
5.8 Closing the unit
When the camera position is set and all adjustments have been
made, close the unit.