Bosch Appliances NIN-832 Security Camera User Manual


 
22 en | Installation FLEXIDOME HD VR
AM18-Q0637 | v1.1 | 2013.08 Installation Manual Bosch Security Systems
6. Using one of the keyholes, hang the mounting base of the
camera module on one screw temporarily; tilt the base
slightly to gain access to the cable connections.
7. Make the connections as outlined in section 5.3 below.
5.3 Connections
5.3.1 Make the connections
Connection box
The unit has connection terminals on flying leads. In wet or
outdoor installations make use of a field wiring box with
NEMA Type 4X or IP66 protection level or better.
1. Make the connections inside a water tight compartment.
Isolate unused power wires individually.
2. After connections are made ensure that the watertight
compartment is tightly closed and cables and conduits are
properly sealed to prevent ingress of water.
CAUTION!
Isolate unused power wires individually to prevent short-
circuits.
Check the type label on the the camera module for the correct
power ratings.