Filter
Top Products
WZ16 Integrated IR Bullet Camera Installation and Connection | en 15
Bosch Security Systems, Inc. Installation Manual | 1.0 | 2011.02
3 Installation and Connection
1. Select a mounting surface that is strong enough to support
the camera.
2. Connect the camera to either a 12VDC (recommended for
best picture and the most stable camera operation) or 24
VAC regulated power supply.
3. Face the camera away from the sun or any bright or
reflective light. Excess light on the lens may cause smear
on the picture and possible damage to the CCD.
DANGER!
RISK OF ELECTRIC SHOCK! DO NOT OPEN THE UNIT!
WARNING!
To prevent injury, this apparatus must be securely attached to
the floor/wall in accordance with the following installation
instructions.
CAUTION!
Do not install the camera near electric or magnetic fields. If
possible, do not install in a kitchen or boiler room as heat will
affect the camera.
CAUTION!
Do not use a power source other than the one specified. An
unregulated power supply cancause damage to the camera. Use
of an unregulated power supply will void the productwarranty.
CAUTION!
To prevent humidity problems, the camera must be installed in
dry conditions, and the cable leads should be sealed once
connected.