Filter
Top Products
Integrated IR Bullet Camera Configuration | en 17
Bosch Security Systems, Inc. Installation Manual | 2.0 | 2011.06
4.1.1 Adjusting Pan, Tilt, Rotate
1. Locate the 3 set screws on the bracket, as identified (6, 7,
8) in the figure above.
2. Loosen the 3 set screws using the supplied hex key.
3. Adjust the pan, tilt, and rotate as necessary.
Figure 4.2 Camera Pan, Tilt, and Rotate
4.1.2 Adjusting Focus
1. Remove the cap covering the bottom of the camera.
2. Adjust the focus knob as necessary (see Figure 4.1 above).
3. Replace the cap over the bottom of the camera.
NOTICE!
Do not pan or rotate beyond 360˚ as shown in the figure below.
Do not tilt beyond 90˚ as shown.
Do not apply excessive force when adjusting the camera
positioning.