Bosch Appliances WZ45N Security Camera User Manual


 
FCC Note
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. As part of its’ normal
operation this device can generate radio frequency energy and if not
installed and used in accordance with the installation manual may
cause interference to radio communications. However, there is no
guarantee that interference will not occur on a particular installation. If
the device does cause interference to radio or television reception the
user is encouraged to try to correct the interference by one or more of
the following measures:
1) Fit Ferrite beads on all cable to and from the power
supply box, within the box walls.
2) Route the composite cable between the camera and the power
supply in steel conduit piping over the entire run of the cable up to and
including connection to a deep conduit base fitted under the camera
and a conduit fitting adaptor in the wall of the PSU box.
3) Contact a BOSCH Service Center for further advice.