Filter
Top Products
QUICK GUIDE: BUSHNELL IMAGEVIEW 11-0718
INSTALL BATTERIES AND TURN ON THE CAMERA
Insert 2 AAA alkaline batteries as indicated inside the battery compartment, located
at the side of the left eyepiece. Turn the camera on by pressing and holding the
MODE button until the display comes on and the camera beeps. To turn the unit off,
press and hold the MODE button until the display goes out. The camera will turn itself
off automatically to save batteries if none of the buttons have been pressed for three minutes.
ADJUST THE BINOCULAR FOR COMFORTABLE VIEWING
Adjust the center focus wheel (located between the eyepieces on the bottom of the camera) while viewing
a distant object through the binocular, until it appears sharp. Holding your ImageView by the raised dot
and ridge grip areas, carefully slide the left and right sides of the camera farther apart or closer together
until you see a single circular image through the eyepieces. Rotate the diopter adjustment (dial with index
marks on the bottom front of the ImageView) to find the best setting for your vision if the image does
not appear as sharp to your right eye as it does for your left eye (close your left eye while you turn the
dial, then check with both eyes open). Note the index settings for your eyes on both this diopter adjust
dial and the IPD scale that is visible when the left/right halves are slid apart. This will make it easier to
reset later if someone else uses your ImageView.
CHECK CAMERA SETTINGS
Make sure the camera is set for high quality (“LQ” does not show on the LCD display-see full instructions
for setting photo quality) if you want the best results, especially if you will be printing the photos. See
“Changing Operational Modes” for full instructions in using features such as repeat shot, movie clips (avi
mode), and deleting a photo you have just taken.
ENGLISH
11-0718 6LIM.indd 4-5 7/19/04 8:50:22 AM