Filter
Top Products
24
4.1.11 Setting the Timer
This parameter is only valid in the ON mode and denes a certain time
lapse in a day when the BUSHNELL TROPHY CAM can be triggered. In
the rest of the time the device is shut o. The eective value of the hour
ranges from 0 to 23 while the minute ranges from 0 to 59. The setting of
this parameter is similar to that of date and time.
Please note that the start and stop time can only be eective when the
timer is set to the value of “On”. Provided that the device should work
from 8am to 5pm, in MENU state detailed operations are as follows:
a) In MENU state push the UP or DOWN key until the parameter “Timer
Switch” appears as shown in the Fig. 15(a) and 15(1).
b) Push the RIGHT or LEFT key at rst. Then the value of this parameter
will be changed to “On”, shown in the Fig. 15(b) and 15(2).
c) Push the OK key to enter into setting start time. Then the hour of
start time can be set as shown in the Fig. 15(c) and 14(3).
d) Push the UP or DOWN key until the hour of start time changes to 8
as shown in the Fig. 15(d) and 15(4).
e) Press the RIGHT key to set minute of start time as shown in the Fig.
15(e) and 15(5).
f) Push the UP or DOWN key until the minute of start time changes to
0 as shown in the Fig. 15(f) and 15(6).
g) Press the RIGHT key to set hour of stop time as shown in the Fig.
15(g) and 15(7).
h) Push the UP or DOWN key until the hour of stop time changes to 17
as shown in the Fig. 15(h) and 15(8).
i) Press the RIGHT key to set minute of stop time as shown in the Fig.
15(i) and 15(9).
j) Push the UP or DOWN key until the minute of stop time changes to
0 as shown in the Fig. 15(j) and 15(10).
k) Press OK key for saving timer setting or MENU key for canceling
operation and exiting. After pressing OK key the selected value will
be no more highlighted, shown in the Fig. 15(k) and 15(11). Next
press MENU key to return to preview state.