Filter
Top Products
16
=Loading and Unloading Film
If the film is not loaded properly, the <=> icon will blink on the LCD
panel and the shutter will not work. Reload the film cartridge
properly.
• The shutter curtains have been manufactured with very high
precision. Never touch them with your fingers. When loading film,
do not touch or damage the curtains with your fingers or film.
• In hot and humid environments, do not remove the film packaging
until you are ready to load the film.
• Infrared film cannot be used with this camera.
After the film’s last frame is exposed, the camera rewinds the film
automatically.
Unloading Film
After the film is rewound, there will
be a shutter-release sound. Check
that the <=> icon is blinking on the
LCD panel, then open the back
cover and take out the film cartridge.
To rewind the film in midroll, follow the procedure below.
¢Midroll Rewind
Press the <¢> button.
sFilm rewind will begin.
•
Make sure the <=> icon is
blinking, then take out film
cartridge.
If you take out the film cartridge in midroll without rewinding the film
and then load a new roll of film and press the shutter button
completely, the new film will only rewind into the cartridge. Before
loading a new roll of film in this case, close the camera back and
press the shutter button.