Filter
Top Products
32
Load a fully charged Battery Pack LP-E10 into the camera. The camera
can use an SD, SDHC, or SDXC memory card (sold separately). The
captured images are recorded onto the card.
Make sure the card’s write-protect switch is set upward to
enable writing/erasing.
1
Open the cover.
Slide the lever as shown by the
arrows and open the cover.
2
Insert the battery.
Insert the end with the battery
contacts.
Insert the battery until it locks in
place.
3
Insert the card.
As shown by the illustration, face
the card’s label side toward the
back of the camera and insert it
until it clicks in place.
4
Close the cover.
Press the cover until it snaps shut.
When you set the power switch to
<1>, the number of possible shots
(p.36) will be displayed on the LCD
monitor.
Installing and Removing the Battery and Card
Installing the Battery and Card
Write-protect switch
COPY