Canon 2 MC Camcorder User Manual


 
90
E
Editing
4. Press AUDIO DUB.
AUDIO DUB. and appear on the display.
5. Press the PAUSE button (and start play on the other audio device
if AUDIO IN).
Audio dubbing starts.
If MIC. IN, direct your voice into the microphone.
changes to .
6. When you get to the point where you want to stop dubbing, press
the STOP button (and then stop play on the other audio device if
AUDIO IN).
Audio dubbing stops and AUDIO DUB. disappears from the display.
The camera returns to stop mode.
You can also set zero set memory ( 79) at the place you want to stop
audio dubbing, then every time you return to that position, audio dubbing
will cancel.
If instead of pressing STOP you press PAUSE, the camera will return to the
playback pause mode.
You can not use the DV terminal while adding sound.
You might want to adjust the audio mix ( 91) when playing back a tape with
added sound.
There may be a loss of sound quality if you add sound to a tape recorded on a
camcorder other than the ELURA2/ELURA2 MC.
After adding sound 3 or more times to the same place on a tape, there may be
some loss in sound quality.
4_ELURA2_E(80-92) 7/25/00 17:16 Page 90