Filter
Top Products
14
Using a Household Power Source
The LCD screen's backlight is brighter when the camcorder is powered from a
household power source.
1. Turn the POWER switch to OFF.
2. Connect the power cord to the
power adapter.
3. Plug the power cord into a power
outlet.
4. Connect the power adapter to the
camcorder’s DC IN terminal.
❍ Turn off the camcorder before connecting or disconnecting the power adapter.
❍ If the adapter is used close to a TV, it may cause picture interference. Move the
adapter away from the TV or the antenna cable.
❍ Do not connect any products that are not expressly recommended to the
camcorder’s DC IN terminal or to the power adapter.
❍ You may hear some noise from the power adapter during use. This is not a
malfunction.
❍ Do not disconnect and reconnect the power cord while charging a battery
pack. Charging may stop. The battery pack may not be charged correctly even
if the CHARGE indicator glows steady. The battery pack may also not be
charged correctly when a power outage occurs during charging. Remove the
battery pack and attach it back to the camcorder.
❍ When the power adapter or battery pack is defective, the CHARGE indicator
flashes rapidly (at about 2 flashes/second) and charging stops.
❍ The CHARGE indicator informs you about the charge status.
0-50%: Flashes once every second
More than 50%:Flashes twice every second
100%: Glows steadily
q
w
e
r
CAMERACAMERA
(VCR)
PLAY
NETWORKNETWORK
POWER
OFF
2_D82NTSC_E(13-37) 1/30/04 14:27 Page 14