Filter
Top Products
112
Memory Card Operation
Printing
Editing
The tape stops during
playback pause.
When playback pause continues for more than 4 minutes 30
seconds during playback or audio dubbing, the camcorder
shuts off to protect the tape and video heads. When audio
dubbing, restart the playback of the tape and press the PAUSE
button on the wireless controller.
–
Problem Solution
Memory card cannot be
inserted.
Memory card was not facing the correct direction. Turn the
memory card over and reinsert it.
20
Memory card cannot be
recorded.
Insert a memory card. 20
Memory card is full. Replace the memory card or erase
images.
83
Memory card is not initialized. Initialize the memory card. 85
The folder and file numbers have reached their maximum
value. Set [FILE NOS.] to [RESET] and insert a new memory
card.
68
If you are using an SD memory card, make sure the card
protection tab is set to allow recording.
–
Memory card cannot be
played back.
Set the switch to PLAY and the TAPE/CARD switch to
.
40
Insert a memory card. 20
Image cannot be erased. Image is protected. Cancel the protection. 84
“ ” flashes red. Card error occurred. Turn off the camcorder. Remove and
reinsert the memory card. Initialize the memory card if flashing
persists.
85
Problem Solution
The printer is not operating
even though camcorder and
printer are correctly
connected.
1. Set the switch to PLAY and the TAPE/CARD switch
to .
2. Disconnect and reconnect the USB cable.
3. Turn off the printer and turn it back on.
–
Problem Solution
Dubbing via the camcorder’s
DV terminal does not work.
Set [AV DV] to [OFF]. 93
Wrong signal standard. Dubbing may work via the AV terminal.
Refer also to the instruction manual of the connected device.
–
Problem Solution