Canon FA-495 Digital Camera User Manual


 
10
Low Light mode enables great shots in dimly lit situations, while Smart Flash Exposure technology
enables the user to balance the flash to avoid over or under exposure.
New Scene Modes - such as Super Vivid for additional bursts of color and Poster Effect for a unique
artistic look, which give the shooters more creative freedom to capture images their way.
Large, clear 2.5-inch LCD makes taking and viewing images a breeze.
This AA battery-powered camera enables you to easily power up on the go.
USING THE FANTASEA FA-490/495 HOUSING
OPENING THE HOUSING
1. Release all four latches at the same time, and lift off the back half to open the housing.
INSERTING THE CAMERA
Since the Fantasea FA-490/495 is specifically designed for the PowerShot A490 & A495 digital cameras,
inserting the camera into the housing is quite simple.
1. Mount the camera on the removable tray, using the mounting tripod screw.
2. Slide the tray and camera into the housing tray slot. Make sure it is completely inserted.
3. Make sure the camera lens is more or less centered in the rounded port area and that the lens does
not distort the round black rubber seat. The housing is designed to have the camera fit in place
perfectly, but if you are not careful, it is possible to put it in at an improper angle and it will then be
impossible to establish a proper seal or easy closure of the housing.
Note
It is strongly recommended to take the first dive without the camera
inside the housing. You should check that the watertight seal has not
been affected during transport and long periods of storage.