Canon vb-s800d Security Camera User Manual


 
74
(1) Video Display Area
Displays video currently captured by the camera.
(2) [Resize] button
Each time this button is clicked, the screen size of the
video display area switches between “480 x 270” and
“960 x 540”.
(3) [Reconnect] button
The camera is reconnected.
(4) [Zoom] slider, [Zoom] buttons
These control the digital zoom ratio.
The [Zoom] slider zooms in (telephoto) by moving the
knob upwards or zooms out (wide-angle) by moving
the knob downwards.
The [Zoom] buttons zoom in or out continuously while
pressed, and stop when released.
(5) [Control for Admin] button
This button displays the [Exposure Compensation]
slider.
(6) [Image Flip] selection box
Select the orientation of the camera video. If [Enable]
is selected, the video is displayed rotated by 180
degrees.
(7) [Save settings]
Save the current zoom and [Image Flip] settings in the
camera.
If the zoom or [Image Flip] settings have been
changed, be sure to save the settings in the camera
using the [Save settings] button.
(8) [Restore settings]
Discard the settings you have specified and restore
the settings saved in the camera.
Note
[Camera Angle] can be operated from the Setting menu only
on the VB-S800D/VB-S900F. It cannot be operated from Admin
Viewer or VB Viewer.
Connecting to the camera from the [Camera Angle] menu will
disconnect connections from each type of viewer and
recording software that are not connected via RTP.
The higher the digital zoom ratio, the lower the video quality
becomes.
Revise the following settings after saving the [Camera Angle]
settings.
- Privacy mask settings
-Preset settings
- Intelligent function settings
[Camera Angle] supports connection to a single camera for up
to 30 minutes.
Setting the Exposure Compensation
You can set any of nine levels of video brightness.
To darken the video, drag the slider toward [Dark]. To
brighten the video, drag the slider toward [Bright].
Note
The exposure compensation value set by [Camera Angle] is
not reflected under [Camera] > [Initial Camera Settings] >
[Exposure Compensation] (p. 42).
After [Exposure] is set to [Manual] and adjusted in Admin
Viewer (p. 135), [Exposure] is automatically reset to [Auto].
[Camera Angle] Digital Zoom Settings
The following can be set here.
Zoom operations
Operate the digital zoom function.
Image Flip
Flip the video image vertically.
Control for Admin
Set the exposure compensation.
(1)
(2)
(3)
(4)
(5)
(6)
(8) (7)