Filter
Top Products
VIEWING IMAGES ON A COMPUTER
200
Using the Camera with a Macintosh
Computer
The following are the general steps for viewing and copying
files from a Macintosh.
You can find details about each operation in the
procedures that follow below. Note that you should also
refer to the documentation that comes with your Macintosh
for other information about USB connections, etc.
IMPORTANT!
•
This camera does not support operation on a
computer running Mac OS 8.6 or lower, or Mac OS X
10.0.
If you have a Macintosh running Mac OS 9 or
OS X (10.1, 10.2, 10.3 or 10.4), use the standard
USB driver that comes with your OS.
1. Load the fully charged batteries into the camera, and
configure the required camera settings for USB
connection to a computer.
2. Use the USB cable to establish a connection between
the camera and your Macintosh.
3. View and copy the images you want.
IMPORTANT!
• Low battery power can cause the camera to power
down suddenly during data communication. Use the
optional AC adaptor is recommended to power the
camera during data communication with a computer.
• If you want to transfer files from the camera’s built-in
memory to a computer, make sure there is no
memory card loaded in the camera before you
connect the USB cable.