Filter
Top Products
137
Appendix
Language selection
screen appears
when the camera is
turned on.
1)You did not configure initial settings after purchasing the
camera or the camera may have been left with a dead
battery. Check the camera setup (pages 20, 112).
2)There may be a problem with the camera’s memory data. If
this is the case, perform the reset operation to initialize the
camera’s setup (page 116). After that, configure each setting.
If the language selection screen does not re-appear when you
turn the camera on, it means that the camera’s memory
management data has been restored.
If the same message appears after you turn power back on,
contact your retailer or a CASIO authorized service center.
I configured the
date and time
settings after
purchasing the
camera, but they
become incorrect
after I remove the
battery from the
camera.
Load the camera’s battery and reconfigure the time and date
settings (page 20). Do not remove the battery from the camera
for at least 24 hours after configuring time and date settings.
After that, the settings will not be reset if you remove the
battery.
• If you leave the battery loaded for more than 24 hours after
setting the date and time, and they still become incorrect after
you remove the battery, it could mean that the camera’s
setting memory is defective. Contact your retailer or a CASIO
authorized service center.
Problem Possible Cause and Recommended Action