Filter
Top Products
Master/Slave Fixture Linking
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
Often, the setup for Master-Slave
and Standalone operation requires
that the first fixture in the chain be
initialized for this purpose via either
settings in the control panel or DIP-
switches. Secondarily, the fixtures
that follow may also require a slave
setting. Please consult the
“Operating Instructions” section in
this manual for complete instructions
for this type of setup and
configuration.
Hanging Clamp
Note!
Clamp is sold separatel
y
.
Mounting
ORIENTATION
This fixture may be mounted in any safe position provided there is adequate room for ventilation.
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable “C” or “O” type clamp. Adjust the angle of
the fixture by loosening both knobs and tilting the fixture. After finding
the desired position, retighten both knobs.
• When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
• Safety cables must always be used.
• Never mount in places where the fixture will be exposed to rain, high humidity,
extreme temperature changes or restricted ventilation.
Slide-Rails Adjustment
In order to allow for easy adjustment of the bracket along the slide rails, you
must loosen both of the bracket adjustment knobs, and then slide them
together along the slide rails. Once set to the desired location, you must be
sure to tighten them after moving to the new location along the slide rails.
You must push both of
the adjustment knobs
inwards towards the
fixture to allow the
bracket to slide freely
Vue™ 4.1 User Manual 9 7/11/2008 11:57 AM