OPERATION
ENGLISH
OPERATION
ENGLISH
1211
To scan memory locations (continued):
b) Push the CHANNEL SELECT button up or
down to resume scanning memory locations.
c) Press the MODE button to proceed
to other functions.
If you do not press any button within
10 seconds, the radio will automatically
resume scanning memory locations.
(NOTE: If you want to reduce the number
of memory locations being scanned you
need to ”unprogram“ all unwanted locations
by changing both the main channel and
privacy code to 00. See Programming
Memory Locations, page 8.)
Using Call Tones
and VibrAlert
™
Your microTALK
®
radio can alert you to
incoming signals by sounding an audible
call tone, by vibrating silently, or both.
To change ring settings:
1. Pressthe MODEbutton until theRing
Setting iconflashes and thecurrent
setting (Vibrate
+ Ring,Vibrate
Only,or Ring Only)
is displayed.
2. Push the CHANNEL SELECT button up or
down to change the ring setting.
3. Press and release the ENTER button to enter
the new setting, or press the MODE button
to enter the new setting and proceed to
other functions.
Turning Roger Beep Off and On
With Roger Beep turned on, your listener will
hear an audible tone when you release the
TALK button. To change Roger Beep mode:
1. Press the MODE button until the Roger
Beep icon flashes and the current setting
(“on” or “off”) is displayed.
2. Push the CHANNEL SELECT button up or
down to turn Roger Beep on or off.
3. To enter the new setting you can press
and release the ENTER button, or press
the MODE button to enter the new
setting and proceed to other functions.
Turning Keystroke Tones
Off and On
With Keystroke Tones turned on, your unit will
sound beeps each time you press a button or
change a setting. To change Keystroke Tones:
1. Press and hold the ENTER button for
5 seconds to turn keystroketones off. A
double beep will sound and the Beep icon
will disappear.
2. To turn keystroke tones back on, press and
hold the ENTER button for 5 seconds again.
A single beep will sound and the Beep icon
will appear.
(NOTE: The unit must not
be in Lock mode during these steps.)
Changing Call Tone Settings
You can choose between ten different call
tone settings to transmit a unique call alert.
To select a call tone setting:
1. With the power
turned off, press
and hold the CALL
button as you turn
the power on. The
number of the
current call tone setting will display and
the tone will sound for one second, after
releasing the call button.
2. Push the CHANNEL SELECT button up or
down to hear the other call tone settings.
3. With the number of your desired call
tone setting displayed, press and release
the TALK button or ENTER button. Your
selection will be entered.
4. If no buttons are pushed for 15 seconds,
the unit will automatically enter the last
call tone pattern that was displayed.
CHANNEL SELECT
button
ENTER
button
TALK button
ENTER
button
CALL button
Vibrate Only
Vibrate + Ring
Ring Only
MODE
button