Filter
Top Products
5
En
GETTING STARTED
ATTACHING THE WRIST STRAP
Please attach the wrist strap to prevent dropping the camera.
LOADING THE BATTERIES
The camera can use 2x AA alkaline, lithium or rechargeable batteries to operate. Rechargeable Batteries (NiMh)
are highly recommended.
1. Slide the Battery/Memory Card door in the direction of the arrow, and lift it open. (fig.1.1)
2. Insert the batteries according to the polarity indication engraved on the battery contact. (fig.1.2)
3. Shut the Battery/Memory Card door by sliding it in the opposite direction of the arrow, and close it securely.
(fig.1.3)
TURNING THE CAMERA ON AND OFF
The Power button is located on the top of the camera.
1. Press and hold the Power button ( ) for more than 1 second to turn the
camera on.
• The Concord logo will show on the LCD for about 2 seconds.
• If the camera is in Camera Mode ( ) or Video Clip Mode ( ), the
lens cover will open, and the lens will extend out automatically to the
wide-angle position. Do not block the lens from extending out.
• The LCD will turn on automatically and display live viewfinder.
2. To turn the camera off, press the Power ( ) button.
Note: To extend battery life,
• The LCD will be off after 1 minute of inactivity. After the LCD is automatically turned off, the Flash
Ready LED blinks. Press any button to reactivate the LCD.
• The camera will automatically power off after 2 minutes of inactivity. Press and hold the Power ( )
button for more than 1 second to turn the camera back on.
REMOVING THE PROTECTIVE PLASTIC FILM
To prevent the LCD from damaging during transportation, the LCD is covered with a clear plastic film. To get a
clearer view of the subject while taking pictures, please remove the protective film.
1
A
AWB
A
AWB
A
AWB
⁄ ⁄
A
AWB
⁄ ⁄
A
AWB
A
AWB
2
A
AWB
A
AWB
A
AWB
⁄ ⁄
A
AWB
⁄ ⁄
A
AWB
A
AWB
3
A
AWB
A
AWB
A
AWB
⁄ ⁄
A
AWB
⁄ ⁄
A
AWB
A
AWB
GETTING STARTED
fig.1.1 fig.1.2 fig.1.3
A
AWB
A
AWB
A
AWB
⁄ ⁄
A
AWB
⁄ ⁄
A
AWB
A
AWB
DZ4363 UG(514338-02)-E 5 6/15/04, 5:07:18 PM