Filter
Top Products
2
Control of Zoom Maximum Speed
By means of the zoom maximum speed control knob the zoom maximum speed can be
changed in seven steps. Rotate the knob clockwise to increase the speed.
2. QuickZoom Operation
In quickzoom operation, pressing a switch moves the zoom to the tele end
quickly. The operator can use this function in such occasions listed below.
• When rapid zooming to the tele end is required to focus on the object
precisely.
• To confirm, in a moment, the composition of the image in the extreme
close up shot.
Note: If the zoom limit function is used, the zoom will stop at the zoom limit
positions. In this case, the zoom may not reach the tele end or the wide end.
Operation
a. Set the zoom servo/manual select knob to “S”.
b. Keep pressing the quickzoom & auto cruising zoom switch until the zoom
reached the tele end.
c. While pressing the quickzoom & auto cruising zoom switch, perform precise
focusing or confirm the composition of the image in the extreme close up
shot.
d. Release the quickzoom & auto cruising zoom switch. The zoom will move to
it’s former position quickly. (If you press the quickzoom & auto cruising zoom
switch again before the zoom returns to it’s former position, the quickzoom
movement restarts. After this operation, if the switch is released, the zoom
will move to it’s former position quickly.)
Note 1. By setting an appropriate switch in the area of “Function & Mode Select
Switches” (refer to illustration on page 8), the return switch and the VTR switch
can be used also as a quickzoom & auto cruising zoom switch.