Filter
Top Products
31D-Link DCS-5010L User Manual 31
Section 3 - Conguration
Mail
SMTP Server
Address:
SMTP Server
Port:
Sender e-mail
Address:
Receiver e-mail
Address:
User Name:
Password:
This is the domain name or IP address of your external e-mail server.
This allows you to set the port for the SMTP Server. The default value
is 25, and should only be changed if advised by your e-mail provider.
This is the e-mail address listed as the sender for your notication
e-mails.
This is the e-mail address that your notication e-mails will be sent to.
If the SMTP server uses authentication, enter your user name.
If the SMTP server uses authentication, enter your password.
This section allows you to congure your camera to send snapshots and video clips to an e-mail address. If you are not sure what settings to use,
check with your e-mail service provider.
For example, if you want to use Gmail with SSL-TLS for e-mail
notications, you can follow the setup procedure as below:
Step 1 - Enter “smtp.gmail.com” in SMTP Server Address.
Step 2 - Change the SMTP server port number from 25 to 465.
Step 3 - Enter your gmail e-mail address in Sender E-mail Address.
Step 4 - Enter the destination e-mail address in Receiver E-mail
Address.
Step 5 - Enter the user name required to access the SMTP server.
Step 6 - Enter the password required to access the SMTP server.
Step 7 - Select SSL-TLS and then click Save Settings.
Step 8 - Click the Test button to send a test e-mail to the account
listed above.
Note: You can also use STARTTLS, which will use SMTP server port
number 587.
Note: If you want to use a Yahoo SMTP server, the SMTP server address will
be dierent between each registered region, and only SMTP port 465 is
supported for SSL-TLS.