Filter
Top Products
19D-Link DCS-932 User Manual
Section 3 - Configuration
Setup > Wireless
Service Set Identier, an identier for your wireless network.
The default setting is channel 6. Select the same channel that is using by other wireless devices within your network. When
there is interference from the wireless networks that overlap with one another, you may change the channel to obtain maximum
performance for your connection.
Infrastructure is a wireless connection using an access point as a transmission point of all wireless devices. Ad-Hoc is a
wireless connection used without an access point, where your DCS-932 is directly connecting to your PC. This is done using
the on-board wireless adapter on the DCS-932 connected to a wireless adapter on the PC.
This page will allow you to select a wireless network that the DCS-932 was able to detect.
For security, there are three choices; None, WEP, and WPA-PSK / WPA2-PSK. Select the same encryption method that is being
used by your wireless device/ router.
An appropriate Preshared Key, which is needed in order to connect to the wireless network..
SSID:
Channel:
Connection Mode:
Site Survey:
Wireless Security
Mode:
WPA-PSK /
WPA2PSK
Settings:
Wireless Interface
This section allows you to setup and congure the wireless settings
on your camera.