Filter
Top Products
The BX-Ri (Multivoltage) units are adapted for operation on 90 - 260V/50 - 60Hz. Before connecting
for the first time, check to make sure that your Modelling Lamp coincides with the voltage. They must
always be connected to an earthed ( grounded) mains supply. All BX-Ri units have a bayonet mount
and locking ring fitting, for fixing all Elinchrom and Prolinca accessories.
Mount the unit securely to a suitable stand or support.
Remove the black protective cover. DO NOT operate the unit without first removing the black
protective cover.
1.Check that the modelling lamp voltage is correct.
2.Check that the mains switch (2) is in the OFF ("O" position).
3.Insert the mains cable into the MAINS INLET (1) and connect this to a FULLY EARTHED OUTLET
4.Using the mains SWITCH (2), switch the unit ON ("I" position).
5.Connect the synchro cord using the socket (5).
6.Select the power with the touch pad (10)
Operating instructions
(A) Locking ring
Handle
(C) Tilthead with locking
umbrella holder
(B) Protective cover
(26124)
Before you start !
English
Switch and fuse
Mains supply
Mains fuse
Fuse for modelling light
Use only the Elinchrom mains cord. Switch off the unit before the mains cord is connected to the
mains plug.
Standard type 5 x 20 mm, use only tempered fuse 8 AT (code 19022) for BX-Ri.
Note: Before exchanging a blown fuse, switch off the unit and remove the mains cable. Open the
little drawer in the mains plug with a screwdriver and replace the fuse with the spare fuse, which
is placed in its support in this drawer. (N.B. Please don’t forget to check the correct rating of the
fuse!).
Fast type 5 x 20mm, 2.5 AF
Switch off the unit and replace the blown fuse with a new one of the correct rating.
The fastblow fuse will protect the triac of the modelling lamp circuit, the lamp and therefore
the flash tube.
6