Filter
Top Products
5
6. If the wires will be concealed, first connect the camera power and video (observe
polarity for power – connecting reverse polarity will damage the camera and void the
warranty.
7. Attach the camera base to the mounting surface by
passing the larger part of the ‘keyhole’ mounting
holes over the heads of the screw and then twisting
slightly clockwise.
8. While holding the base in the CW position, tighten
the screws, being careful not to over tighten (and if
wire is to be run along the mounting surface, be sure
to pass the wire though the notch in the base).
Adjusting the Camera Direction
Rotate the inner mechanisms to point the camera in the desired direction. Rotate the camera
module on its axis if necessary to align the image ‘upright’. Loosen the screws which lock the tilt
mechanism. Adjust to obtain the desired field of view and tighten the tilt mechanism screws.
Inner Mechanism Camera module
Replace the dome cover removed in step 5 above, twisting the cover CW to lock it in place.
CW
Mounting Holes
Tilt lock
2 places