Filter
Top Products
3-28
For Tour setting: Shift joystick to right and left (< >) for changing Set Numeral
(T01A~T16A), then press “Enter” to confirm.
Shift joystick to right and left for selecting PRE Numeral (position) from 01~99, then press
“Enter” to confirm.
Shift joystick up and down to adjust DWL (dwell) time from 0~99 sec, then press “Enter” to
confirm.
Shift joystick to right and left for adjusting speed (5~235, with an interval of 5), then press
“Enter” to confirm.
For Tour Run:
Shift joystick to right and left for selecting RUN NUM (T01A~T16A) of the tour that you
previously set. Press “Enter” to start running the tour.
Alternatively, you could run the tour without entering MENU. Press “Position + 97” to run
the tour that you have previously set, please be informed that this function is only valid for
T01A.
If you need to reset, press “IRIS –“ of the keyboard to exit.
21. X CNT： X-axis counter. This counter counts the x axis movement, and 1 is counted
when the speed dome pans 360°.
22. Y CNT： Y-axis counter. This counter counts the y axis movement, and 1 is counted
when the speed dome tilts 180°.
23. PO CNT： Position counter. This counter counts the go-position times, 1 is counted
when speed dome goes to a position once.
24. LOAD DEFAULT： Load default setting.