Filter
Top Products
○
6
Power LED: The power LED lights up when power is ON.
○
7
DC Auto Iris Lens Connector: This connector is used to connect with the DC type auto iris lens
using a standard 4 pin male connector
Pin 1 Pin 2 Pin 3 Pin 4
3
1
4
2
Direct Drive Cnt- Cnt+ Drv+ Drv-
3. INSTALLATION
1. Unscrew/remove the cover cap from the lens mount.
2. If C mount lens is used, please add the C adaptor mount ring (the 5mm thick ring in
the accessory pack) between the lens and the mount. Please note: Failure to use a
spacer ring when attaching a C mount lens can damage the camera!
3. Mount the lens by turning it clockwise into the lens mount.
4. If you use an Auto Iris lens, connect the lens cable to the auto iris lens connector on
the side of the camera.
5. After mounting and connecting the camera, when making final focus adjustments,
remove the protective sheets from both sides of the ND filter provided; place the ND
filter in front of the lens to force the lens iris to open; then adjust the lens focus until
the best image is obtained.
6. Lock the lens focus by turning any clamping screws provided on the lens, then
remove the ND filter.
Mounting the lens -----------------5mm C Mount spacer (optional) shown
o--------------------
Light Sensor
TAKE CARE NOT TO OBSTRUCT THIS OPENING
WITH THE BODY OF THE LENS!
- 6 -