Filter
Top Products
g. When all the adjustments and settings are completed, overlaying
the cover gently. Be careful not to damage to the “O”-Ring and
camera components.
h. To reassemble the sun shield, match the hole on the sun shield to
the back fixing plate of camera, Fix the screw on the front fixing
plate. Make sure the wider side of the fixing plate holds the edge
of the camera well.
5. Attach the camera onto the mounting bracket.
6. Loosen the swivel screw and point the camera to the desired
direction.
7. Tighten the swivel screw. To strengthen the fixing power of the
swivel screw, tighten the set-screw with the set-screw wrench.
(supplied)
Notes:
(A) Make wiring connections only after it has been determined that
power has been disconnected.
(B) There is a desiccant pack attached to the housing base under the
camera which is designed to absorb any moisture trapped inside
the housing during adjustment. To avoid excessive moisture
build up, it is recommended that the camera not be installed in
rainy or excessively damp conditions. It is also advisable to
limit the number of times the housing cover is removed. The
desiccant pack can be replaced if condensation develops inside
the housing.
6