Filter
Top Products
16
3 OSD MENU SETUP
This chapter introduces how to change RS485 ID and Baud Rate and to configure the camera
OSD menu.
STEPS
If you want to connect camera with keyboard or other RS-485 - controller, please refer to Section
3.2 RS485 ID & Baud Rate setting. Otherwise, please go to STEP 2.
Configure the camera, as described below:
3.1 Control Key General Operation Guide
Switch between Lens and Menu operation
Press and hold ( ~ 5 s) the joystick button for changing the operation mode of the
joystick. Red LED: Menu mode, Green LED lens control mode.
Bring Up the General OSD Menu
Simply press the mini-joystick to bring up the general OSD menu.
Note: Make sure, that the joystick is in "MENU" mode (red LED under Joystick).
Navigate among the OSD Menu Items
Turn the mini-joystick up (c) or down (d) to move the cursor up or down.
Change Modes or Setting Parameters
Turn the mini-joystick left (e) or right (f) to adjust the mode or value of settings.
Switch to Sub-menu Screens
When an item with a sub-menu is selected, press inward on the mini-joystick to switch to
the sub-menu for further settings. This may also be referred to in the instructions below
as “pressing the setup button”. Please refer to the diagram below.
Chapter
3
Sub-Menu
Main Menu
DC LENS
fBRIGHTNESS |+++++++++| 45
RETURN RET <┘
SETUP EVERFOCUS
1. LENS DC
<┘
2. EXPOSURE <┘
3. WHITE BAL. AWB
4. DAY NIGHT EXT
5. 3DNR ON<┘
6. SPECIAL <┘
7. ADJUST <┘
8. RESET <┘
9. EXIT