Fluke Ti10 Digital Camera User Manual


 
Ti10, Ti25, TiR and TiR1
Users Manual
10
2. Press the softkey labeled Increase to widen the temperature span or
Decrease to narrow it.
3. Press the softkey labeled Done to set the Imager’s range level.
Switching Between PIP and Full IR (Ti10 and
TiR Only)
The Imager can be set to display a full infrared image (Full IR) or an infrared
image surrounded by a visual light image (Picture-in-Picture / PIP). To switch
the Ti10 or TiR Imagers between a full infrared display and Picture-In-Picture
(PIP) display:
1. Press a until Fusion appears over d.
2. Press the softkey labeled Up or Down to toggle the display between PIP
and Full IR.
3. Press the softkey labeled Back/Done when finished.
Setting IR-Fusion
®
and PIP (Ti25 and TiR1 Only)
Blending a visual image with a thermal image is called IR-Fusion
®
. The
Imager is set to one of three different levels of blending. In addition to setting
the visual to thermal blending, the IR-Fusion
®
menu is used to select between
a full thermal image display, or a Picture-In-Picture (PIP) display. To set the
IR-Fusion
®
level and PIP display:
1. Press a until IRFusion appears over d.
2. Press the softkey labeled IRFusion to reveal the IR-Fusion
®
menu.
3. Press the softkey labeled Up or Down to move between the six IR-
Fusion
®
settings. The top three settings select a PIP display. The bottom
three settings have full screen IR with different levels of visible blending.
4. Press the softkey labeled Back/Done when finished.
Reviewing and Deleting Stored Images
To view stored images on the SD card,
1. Press a until Memory appears over c.
2. Press the softkey labeled Memory to reveal the review menu.
3. Press the softkey labeled Review.