Filter
Top Products
7
LOADING THE BATTERY
Your camera uses one 3V lithium battery
CR123A/DL 123A or the equivalent.
To load the battery.
1
Open the battery compartment cover by inserting a small tool into the cover slot.
2 Insert the battery following instructions in the diagram on the inside of the battery cover paying
particular attention to the position of the , and . poles of the battery. The battery must be
inserted the right way or the camera will not operate.
3 When battery is inserted properly, close the battery compartment cover snapping it securely.
∗
Do not apply excessive force when opening the battery cover.
∗
One lithium battery should be sufficient for approximately 200 exposures (based on our test conditions).
∗
When traveling, take extra batteries to provide power for extra exposures, particularly important if you
visit areas where fresh batteries may be difficult to obtain.
∗
Check the battery capacity symbol before using your camera. (→p.8)
∗
After changing battery, reset the date to assure accurate date/time recording. (→p.9)
∗
Do not load film before insertng the battery into the camera.
2
1
3