Filter
Top Products
Confidential: FUJIFILM Service Center Use Only
XF56mmF1.2 R Simple Manual
-For Repair Centers without the Lens Repair Training-
<Step 3>
[Resolution Inspection]
(1) Download the software from the WEB and install the software to the PC.
We have uploaded the “XF56MM RESOLUTION CHECK SOFTWARE (ZJ02286-100.zip)” on our website:
(https://cs-support-eid.fujifilm.co.jp).
(2) Decompress the “ZIP type” file of “ZJ02286-100”.
(3) Copy the “FFRes_XF56mm” folder to the “C” drive on the PC.
(4) Copy shot images in the SD card to “FFRes_XF56mm” folder.
(5) Launch FFRes.exe.
(6) Use [File]-[Picture reading] to open shot images.
(7) When the window shown on the right appears,
click [Yes].
Figure. 3
(8) The screen below will appear. If there is no error (in red) in [brightness] in [Measurement condition check] on the right,
press the [Enter] key to start measurement.
*
* Example error display
*
D
value
•
•
R
•
<S
•
If brightness for [Measurement condition check] shows an error (in red).
o the followings and shoot the chart again so that brightness in [Measurement condition check] becomes a
within the [Standard] brightnessrange.
Adjust the position of the light source (lighting).
Adjust the camera’s exposure compensation.
egarding exposure and lighting
Be sure that the illuminances where measured in each of center and periphery are well-balanced. (refer to
ettings for Resolution Check>)
Adjust overall image’s brightness level by using the camera’s exposure compensation.
10