FujiFilm AF3-151E Film Camera User Manual


 
– 5 –
FUJICOLOR SUPERIA X-TRA 400
[
CH
]
FUJIFILM PRODUCT INFORMATION BULLETIN
14. FILM STRUCTURE
15. DIFFUSE RMS GRANULARITY VALUE .............. 4
Micro-densitometer Measurement Aperture: 48 µm in diameter
Magnification: 12 ×
Sample Density: 1.0 above minimum density
16. RESOLVING POWER
Chart Contrast 1.6 : 1 .......................... 50 lines/mm
Chart Contrast 1000 : 1 ........................ 125 lines/mm
4-2 Processing Solution Control
Use the current 135-size control strips for processing
solution control.
4-3 Processing-Photographic Characteristics
Same as those for SUPERIA 400.
12. PRINTER CONDITIONS
This film can be printed on the same printer setup with
results similar to the current film. However, depending
on the printer type, a slight blue cast might appear in the
overexposed areas. If this occurs, adjustment of printer
conditions may be necessary.
13. JUDGING EXPOSURE RESULTS
SUPERIA X-TRA 400 exposure results can be accurately
predicted by using an electronic densitometer equipped
with Status M filters. An 18% gray card, receiving the
same illumination as the subject, when read through the
RED filter should render density readings between 0.75
and 0.95 (for exposures under recommended lighting
and with optimal film processing).