Filter
Top Products
4600g, 4600r, 4800i User’s Guide 6 - 5
Wand Emulation Idle
The idle describes the state of the imager when no data is being transmitted.
When in Wand Emulation mode, you must set the imager’s idle state to match
the idle state for the device to which the imager is connected.
Default = Idle High
.
Data Block Size
This transmits the data in smaller blocks to prevent buffer overflow.
Default = 40.
Secondary Trigger Mode
Manual/Serial Trigger
You can activate the imager either by pressing the trigger, or using a serial trigger
command (see Trigger Commands on page 12-4). When in manual trigger
mode, the imager scans until a bar code is read, or until the trigger is released.
* Idle High
Idle Low
20
80
* 40
60