Filter
Top Products
2.3 Upgrade
When you select one device or multiple devices (of the same model), the “Upgrade” button will be enabled. Click on it to
pgrade the firmware of the selected device(s). After clicking on the “Upgrade” button, the IP Setup Wizard will try to
onnect to the s to ask for the correct password
nd HTTP port number. (See Figure 2-10 below.)
Figure 2-10. Authentication
.3.1 Device Information
fter connecting to the selected device(s), the display will appear as shown in Figure 2-13 on the following page. If you
elect more than one device, the “Device Info” tab will show all the selected devices. (See Figure 2-11 below.) You can
witch to a specific camera’s info (see Figure 2-12) by pressing the Tab key or double clicking on the device list.
Figure 2-11. Device Info
u
c elected device(s). If the authentication fails, it will prompt a pop-up dialog
a
2
A
s
s
17