Hitachi DZ-MV730E Camcorder User Manual


 
English
159
Card full. Delete unnecessary stills and try the card, or use another card.
32, 107
No more recording on this card can be done: Delete unnecessary
stills or use another card.
Card full.
Cannot execute.
Delete unnecessary stills and try the card, or use another card.
32, 107
Card is not formatted.
Format the card now?
Was the card formatted on PC? When using the card on this DVD
video camera/recorder, choose “YES” and format it.
129
CHECK DISC A disc unusable on this DVD video camera/recorder may have
been inserted or the disc may be damaged.
Make sure that the type of disc is correct, and make sure that the
disc is not write-protected.
28, 130
Control Information
Error.
Mismatch may occur between the recorded image and scene
information.
Update the control information.
131
Use another disc.
See *3 on page 163.
27, 29
DISC ACCESS The recorded scene is being stored on disc.
Wait until the message disappears, and you can start to use the
DVD video camera/recorder.
52, 54
This DVD video camera/recorder is verifying whether the correct
disc has been inserted.
Wait until the message disappears, and you can start to use the
DVD video camera/recorder.
155
DISC ALMOST FULL Remaining free space on disc is less than 1 minute of video or 10
photos: Delete unnecessary scenes or use another disc.
31, 107
Disc error has occurred.
Finalizing is not
complete.
Disc error occurred during finalising, and finalising failed.
Replace the disc.
See *3 on page 163.
132
Disc error has occurred.
Format the disc now?
Has the disc been initialised on PC? Has initialising the disc on
PC been interrupted?
Choose “YES” and initialise the disc when using it on this DVD
video camera/recorder. Initialising the disc will erase all data on
it.
See *2 on page 163.
129
Disc error has occurred.
Formatting is not
complete.
The disc may be dirty.
Remove the disc and wipe off fingerprints, dust, etc. before
reusing it, or use another disc.
This message may also appear if you insert a disc for which
formatting was interrupted midway. In this case, use another disc.
29, 129
Disc error has occurred.
Keep disc inside &
restart.
Disc error could have occurred during editing of scenes.
Turn off the DVD video camera/recorder with the disc being used
in it, connect AC adapter/charger, and then power the DVD video
camera/recorder again. Repair of scenes will be tried.
46
Message Cause & Troubleshooting
Reference
page