English
53
Note:
• See “Check 1” on page 155 when recording movie is
not possible.
• See “Check 4” on page 155 if it takes some time
before recording is possible.
• See “Check 5” on page 156 if the DVD video camera/
recorder does not operate.
• See page 55 for on-screen information display.
• It is recommended that you use DVD-RAM disc from
which recorded contents can be deleted.
• Sound is recorded from the stereo microphone on the
front of DVD video camera/recorder: Take care that
this microphone is not blocked.
• You can press the REC button immediately after the
DVD video camera/recorder enters the recording
pause status, but no further recording can be made
while “DISC ACCESS” is being displayed.
Recording will restart after the message disappears.
• Do not turn power off while message “DISC ACCESS”
is being displayed.
• Take care that power is not interrupted while the
ACCESS/PC indicator is blinking.
• The minimum recordable time of movie is
approximately 3 seconds.
• See page 98 for setting of Record LED (recording
indicator) On/Off.
• For various functions available during recording, see
“Setting Up Camera Functions” on page 85.
• Hitachi cannot be responsible for video and audio that
cannot be recorded or edited because of any defect.
• The power switch can be changed over even during
recording, but the operation will not be changed.
• Each time the DVD video camera/recorder enters the
recording pause status, the counter display will be
reset to “0:00:00”.
• It is recommended that you set the LOCK switch to L
(the upper position) to prevent the power switch in the
“O” position from accidentally moving to “N” position.
• Do not insert a non-finalised DVD-R disc into another
DVD device: Doing so could cause the disc to
become unusable (except in the case of the devices
that have a function that can play back a disc that has
not been finalised on this DVD video camera/
recorder).
• When using an unformatted DVD-R disc, it is
necessary to format it on this DVD video camera/
recorder (see page 49).