Filter
Top Products
If you wish to exchange or copy some of your friend's favorite home recordings, the following instructions can be
used to connect camcorder to VCR for this purpose.
1 Connect the audio/video cable to "AUDIO" and "VIDEO" of your camcorder.
2. Connect the other ends to "AUDIO IN", "VIDEO IN" of your VCR as shown in diagram above.
3. Play the tape on the camcorder and record it on the VCR.
NOTE: If you Connect the ,VHF OUT TO TV,' connecto r of VCR to the ',TV ANT" connector, as illustrated and 1
set .VCR/TV. selector of the VCR to "VCR" mode, the picture being dubbed by VCR can be monitored.
1 Remove the lens hood.
Turn the lens hood counterclockwise as shown in the figure.
Or, attach the lens cap over the lens hood, then turn them counterclockwise to remove them
2 Remove both caps of the telephoto or wide angle lens
3. Screw the lens into the threads on the front of camcorder lens assembly.
Use the built-in camera light if you wish to shoot objects in dark places.
When "LIGHT" is set to "AUTO", the camera light turns on automatically when the camcorder is pointed at
objects in a dark place and turns offwhen it is pointed at objects in a bright place.
CAUTION: The power consumption of the built-in camera light is about a half that of the camcorder. Therefore, 1
if the camera light is turned on when a fully charged battery pack is attached, the operating time Ofthe battery
falls to about a half.